AUTORESTART=NO_RESTART, START=STOP, ABTOINTCLR=WRITING_A_0_HAS_NO_I, ABEOINTCLR=WRITING_A_0_HAS_NO_I, MODE=MODE_0_
Auto-baud Control Register. Contains controls for the auto-baud feature.
| START | Auto-baud start bit. This bit is automatically cleared after auto-baud completion. 0 (STOP): Auto-baud stop (auto-baud is not running). 1 (START): Auto-baud start (auto-baud is running). Auto-baud run bit. This bit is automatically cleared after auto-baud completion. |
| MODE | Auto-baud mode select bit. 0 (MODE_0_): Mode 0. 1 (MODE_1_): Mode 1. |
| AUTORESTART | Auto-baud restart bit. 0 (NO_RESTART): No restart 1 (RESTART_IN_CASE_OF_T): Restart in case of time-out (counter restarts at next UART1 Rx falling edge) |
| RESERVED | Reserved, user software should not write ones to reserved bits. The value read from a reserved bit is not defined. |
| ABEOINTCLR | End of auto-baud interrupt clear bit (write-only). 0 (WRITING_A_0_HAS_NO_I): Writing a 0 has no impact. 1 (WRITING_A_1_WILL_CLE): Writing a 1 will clear the corresponding interrupt in the IIR. |
| ABTOINTCLR | Auto-baud time-out interrupt clear bit (write-only). 0 (WRITING_A_0_HAS_NO_I): Writing a 0 has no impact. 1 (WRITING_A_1_WILL_CLE): Writing a 1 will clear the corresponding interrupt in the IIR. |
| RESERVED | Reserved, user software should not write ones to reserved bits. The value read from a reserved bit is not defined. |